Geekstory BN-220 Dual GPS Glonass Module Navigation+GPS Passive Antenna with Flash TTL Level for Arduino Raspberry Pi Pixhawk F3 CC3D Betaflight F4 Flight Control(Pack of 2PCS)

geekstory bn 220 dual gps glonass module navigationgps passive antenna with flash ttl level for arduino raspberry pi pixhawk f3 cc3d betaflight f4 fl

When it is used on Raspberry Pi, it is not necessary to install the driver, but the software must be installed
The TX LED flash means gps module output normally.The PPS LED flash means gps module locate your place.
Data Level : TTL or RS-232,Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable

Brand : Geekstory
Category : Electronics,GPS, Finders & Accessories,GPS System Accessories,Antennas
Rating : 4.5
Price : US $42.99
Review Count : 5

geekstory bn 220 dual gps glonass module navigationgps passive antenna with flash ttl level for arduino raspberry pi pixhawk f3 cc3d betaflight f4 fl

These little GPS modules are great for adding a layer of safety to your race quad. Just hookup to power (3-5V), ground, TX and RX of an available UART on your flight controller then setup in Betaflight and you are ready to go. There are lots of good tutorials on Oscar Liang or YouTube to guide you along. You can program these modules using U-Center using the U-Blox protocol to set a higher data and refresh rate for better accuracy. They are a great GPS for the money.

GPS ACCESSORIES